WG GSM Wireless Extreme 4 Alarm System

Product Information

WG GSM Wireless Extreme 4 Alarm System

This WG GSM Extreme 4 Wireless Alarm System is supplied with a Serious 120Db Siren & Flashing Strobe, 3 x PIR's, 1 x Smoke Detector, 2 x Remote Controls, 3 x Magnetic Contacts, 2 x Vibration Sensors & 1 x Panic Button.

The Alarm has an impressive 99 Wireless Channels & 7 hard wired channels and when activated can send 3 text messages 6 telephone calls with your own pre-recorded message.

The H/D Wireless Siren has flashing LED's in standby mode and rapid flashing LED's and Twin Sirens giving an output of 120 decibels when activated, it is powered by using the supplied plug in transformer and has built in battery back up, a very serious deterrent.

The system is very easy to program using the built in keypad and is operated using a selection of methods including using the keypad, remote controls, text message or automatic timing.

A wide choice of additional accessories are available for this 99 channel GSM Alarm System, all 99 channels can be individually programmed to suit all types of applications including the following options:
1) Instant Alarm.
2) 40 Second Delay.
3) 24 Hour.
4) Bypass.
5) Home Alarm.
6) Away Alarm.

You will need to fit a SIM Card (either contract or pay as you go) with a good network signal at the location of the alarm installation.

The alarm will also send you a text if the power supply is cut or fails and again when it is reinstated.

The 7 x Wired Inputs can be used as both N/O & N/C allowing you to mix and match the type of detectors or triggers with each system.

There are also 2 x 12v DC Outputs when triggered.

Kit Includes:
1 x GSM Dialer.
1 x Power Adapter.
1 x Wired Siren.
3 x PIR's.
3 x Magnetic Contact's.
2 x Remote Control.
1 x Backup Battery.
1 x Wireless 120Db Siren, Transmitter & Transformer.
1 x Smoke Detector.
1 x Wireless Panic Button.
2 x Wireless Vibration Sensors.
1 x Manual.

Receiver Specification:
Size of Panel: 180 (w) x 135 (h) x 26 (d) mm.
Power Supply: 12v DC.
Wireless Channels: 99.
Wired Inputs: 7
Input Type: Volt Free N/O & N/C.
Outputs: 12v DC (3 minutes when activated, can be switch off).
Number of Text Messages it can send: 3
Number of Telephone Numbers it can call: 6.
Personal Message Recording: Yes (10 seconds).
Power Failure Alert: Yes.
Remote Location Function: Yes (Arm, Disarm & Monitor).
Zone Type Options: Yes (Instant-Delay-24 hour-Bypass-Home-Away).
Backup Battery: Yes (NI-HI AAA x 6 7.2v).
Standby Current: 55 m/A.
Alarming Current: 450 m/A.

*Please Note: A maximum of 99 wireless mixed sensors can be used with each system*

Procedure for Receiving Telephone Call:
Press 1: Stops Alarm, Stops Calling Out & Left in Arm Mode.
Press 2: Stops Alarm, Stops Calling Out & Left in DisArm Mode.
Press 3: Siren Off & Monitor Location for 30 Seconds (press 3 for further monitoring).
Press 4: 30 Second two-way intercom.
Press *: Status.

How to Remotely Operate:
1) Call Telephone Number of the Inserted SIM Card.
2) Enter the 4-Digit User Code of the Alarm Panel.
3) Press 1 = Arm.
4) Press 2 = Disarm.
5) Press 3 = Monitor.
6) Press 4 = 2 way Communication.

Methods of Arming & Disarming:
1) Remote Control.
2) Built in Keypad.
3) Sending the alarm a Text Message.
4) Setting the automatic timer.
*Please Note: the user code is different to the program code*

Programmimg Method:
1) In disarm state enter the default 4-digit program code & #.
2) Use the keypad to follow instructions for each action.
3) Leave program mode by pressing * & #.
*Please Note: the program code is different to the user code*

PIR Specification:
Size: 110 (H) x 60 (W) x 45 (D) mm (without bracket).70 mm deep with bracket.
Detection Range:10 metres Distance x 110 Degrees.
Power Suppy: 1 x PP3 Battery.
Battery Life: Approximately 6 - 12 months (normal use).

Mounting the PIR Sensor:
The key to successful operation of any PIR sensor is choosing the correct location. A sensor mounted in a unsuitable location has the potential to cause false triggers and reduce performance. The main rules that should be followed are:
1) Mount the PIR into a corner of a room.
2) Avoid heat spots from bright lamps suddenly turning on or off.
3) Do not install immediately above a radiator.
4) Do not install in a glass roof conservatory.

Magnetic Contact Specification:
Size (not including extendable aerial):
Switch: 70 (L) x 35 (W) x 15 (D) mm.
Magnet: 65 (L) x 12 (W) x 13 (H) mm.
Battery Type: 12v MN21.
Battery Life: 12 - 18 months (normal use).

Installation Method:
Switch: Double sided tape (included).
Magnet: Double sided tape & self 2 screws (supplied).

Remote Control Specification:
Size:56 (L) x 34 (W) x 13 (D) mm.
Total that can be used per system: 8
Battery Life: 1 - 3 years (normal use).
Battery Type: 12v MN27.
Transmission Distance: 60 metres (line of sight).

Wireless Siren Specification:
Size of Siren: 325 (H) x 220 (W) x 70 (D) mm.
Power Supply: 12v 1amp Transformer (supplied).
Back Up Battery: Yes (12v 1.2amp).
Siren: Yes x 2 (120 Db).
Strobe in Standby: Yes (slow).
Strobe when activated: Yes (Rapid).
Tamper Switch: Yes (rear & side).
Wireless Range between the Siren & Transmitter: 300 metres (line of sight).

Smoke Detector Specification:
Size: 105mm Diameter x 35mm deep
Colour: Creme
Power: 9v PP3 battery (supplied)
Transmission Range: 100 metres.
Frequency: 433 Mhz.
Battery Life: Approximately 1 year.
Operating Temperature: 4 - 37.8 Degrees.
Complies to: CE - U1217 - BS5446 Part 12000.

Vibration Sensor Specification:
Size:
Switch: 70 (L) x 35 (W) x 15 (D) mm.
Extendable Aerial from 40 - 140 mm.
Installation Method:
Switch: Double sided tape (included) or additional screws for some H/D applications (not included).
Battery Type: 12v MN21.
Battery Life: 6 - 12 months (normal use).

Wireless Panic Button Specification:
Size: 40 (w) x 70 (w) x 17 (d) mm.
Power: 12v Battery (MN21)
Wireless Transmission Range: 100 metres (line of sight).

Remote Control Specification:
Size: 52 (L) x 28 (W) x 10 (D) mm.
Battery Life: 1 - 3 years (normal use).
Battery Type: 12v MN27.
Transmission Distance: 60 metres (line of sight).

There are a multitude of Additional Accessories that can be added to this Alarm system, including:!!
Pet Friendly PIR's.
Curtain PIR's.
Additional Wireless Sirens.
Wireless keypad.
Panic Buttons (push & wrist options).
Smoke & Heat Sensors.
Gas Sensors.
Power Failure Sensors.
Vibration Sensors.
Range of Water Detectors.
Roller Shutter & Gate Contacts.

The power supply is a 12v DC transformer that plugs into a standard 3 pin wall socket, but you could connect the system directly into a 12v DC supply.

Find this model advertised for the UK at any reputable internet dealer for less... and we will beat that price!

Price: 389.95

• Tell a Friend